SETUP
YOUR ITALIANO WATCH
SETUP YOUR ITALIANO WATCH
Thank you for choosing us and congratulations!
Now you own an Italiano watch from the first series.
Your Italiano watch mounts a Swiss Made Sellita sw200 Automatic movement, it is recharged by the rotor that you can see on the back.
This rotor oscillates 28,800 times in an hour and produces energy for 4hz. The power reserve of your watch lasts 38h.
It means that if you don’t wear it for a while your watch will stop and you will need to put it back on time, no problem.
Below we illustrate you how.
INSTRUCTIONS:
The crown of the Italiano watch is a screw crown, this to ensure water resistance up to 100 meters. It means that to use it first you have to unscrew it by following these simple steps:
1. Twist the crown down, grabbing it with two fingers.
2. You will hear a “click” and the crown will go out altogether. At this point you can make her do:
1 click to change date / 2 clicks to adjust time
3. Once you have set the date and time, simply close the crown (1) and then screw it with a slight pressure (2) to prevent the spring from releasing it.
BRACELET:
To guarantee the highest quality, the links of your bracelet are screwed with small screws.
We have provided you with a small screwdriver that will allow you to easily remove excess links from your bracelet and put it to measure.
We recommend that you first remove the central meshes and symmetrically, two on one side and two on another, if you need to remove an odd number of meshes we recommend keeping the inner side shorter.
Make sure you are resting on a plane when you proceed to remove the meshes. Check the side of the screw head. Then unscrew it counterclockwise.
If you have any difficulties, please contact your local watchmaker or jewellery dealer.
Thank you for your trust and do not hesitate to contact us via chat or email for any further questions.
